No LNB

[sammyhere2]

Hi trying to set up my dish useing Diseqc 1.2 or USALS got 1 sat then try to put in other it cant find it or just goes back to first 1 it says on bottom of the positioner setup page no LNB useing factory defaults, any help would b great

[Sicilian]

See screenshot below, replace logitude and latitude to your area setting.

Menu > Setup > Service Searching > Tuner Configuration.

http://www.world-of-satellite.com/attachment.php?attachmentid=382&d=1274390993

[sammyhere2]

i done that and the dish goes way off when i put my spiderbox back on and does that aswel, im in newcastle. west side, its says should be long 1degre lat 54 i must b doing something wrong ?

[Sicilian]

Sounds like your longitude and latitude may be wrong or a dish alignment issue check it.


http://www.dishpointer.com/

[sammyhere2]

ive checked that

[Sicilian]

If the dish goes way off, then you have an alignment issue.

[sammyhere2]

i guess that must be it cheers

[sammyhere2]

do you think the best way is to set it to 28.2 then swing dish back around but leave moter were it is ?

[Sicilian]

do you think the best way is to set it to 28.2 then swing dish back around but leave moter were it is ?

The best way is to have the motor aligned correctly by engineer if you are not sure how to align it correctly.

[sammyhere2]

sorted, i put motor to 0 realigned dish to thor. happy :)