View Full Version : Need help with new receiver setup please
Just changed over from a spider box to a giga blue 800ue, I already have a v u * duo which i use on a fixed dish. I am trying to set the gigablue up on a 1.2 motorised dish that i used with the spider box. I am a little stuck and would like a guide on how to setup the gigablue with diseq 1.2 , any help much appreciated.
Thanks
try this it's the same basic process.
Thanks i will give it a go.
Thanks i have followed the guide dish is moving but have no signal?
I have tried moving the dish via positioner setup east to west but still no signal, Any ideas please?
I assumed that you already did a scan, after Tuner setup.
Is there any service data in positioner setup, if not put it in on a Satellite you are trying to locate then check SNR is locked and a decent reading.
Theres currently a driver bug on all gigablue models that affects satfinder and snr/agc readings. Move to satellite and run a scan.
Thanks i have it all under control now :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.