Need help with new receiver setup please

[jgtis]

Just changed over from a spider box to a giga blue 800ue, I already have a v u * duo which i use on a fixed dish. I am trying to set the gigablue up on a 1.2 motorised dish that i used with the spider box. I am a little stuck and would like a guide on how to setup the gigablue with diseq 1.2 , any help much appreciated.

Thanks

[Larry-G]

try this it's the same basic process.

[jgtis]

Thanks i will give it a go.

[jgtis]

Thanks i have followed the guide dish is moving but have no signal?

[jgtis]

I have tried moving the dish via positioner setup east to west but still no signal, Any ideas please?

[Alec]

I assumed that you already did a scan, after Tuner setup.
Is there any service data in positioner setup, if not put it in on a Satellite you are trying to locate then check SNR is locked and a decent reading.

[Sicilian]

Theres currently a driver bug on all gigablue models that affects satfinder and snr/agc readings. Move to satellite and run a scan.

[jgtis]

Thanks i have it all under control now :)