shaft
13-10-12, 17:58
I am sometimes getting a Tune failed message after a reboot etc.
I have twin tuners on an ET9200 fed from a quad LNB (only two connected), here are my config settings:
Tuner A: AVL2180 (DVB-S2)
Configuration Mode: Simple
Mode: DiSEqC A/B
Port A: 28.2E Eutelsat 28A..Astra1N/2A/2B
Port B: 28.2E Eutelsat 28A..Astra1N/2A/2B
Set voltage and 22Khz: Yes
Send DiSEqC only on satellite change: No
Tuner B: AVL2180 (DVB-S2)
Configuration Mode: Simple
Mode: DiSEqC A/B
Port A: 28.2E Eutelsat 28A..Astra1N/2A/2B
Port B: 28.2E Eutelsat 28A..Astra1N/2A/2B
Set voltage and 22Khz: Yes
Send DiSEqC only on satellite change: No
I can correct the failure by going into 'Sat finder' (in 'Service searching') selecting a tuner and toggling between Tune> Manual transponder and Predifined transponder, exit, then selecting 'yes' to Zap back to service before sat finder.
Now that I think about it, I don't think it's happened since changing to Rob's Magic HD skin, but if anyone can see any errors with my tuner set up - please let me know.
Thanks
shaft.
I have twin tuners on an ET9200 fed from a quad LNB (only two connected), here are my config settings:
Tuner A: AVL2180 (DVB-S2)
Configuration Mode: Simple
Mode: DiSEqC A/B
Port A: 28.2E Eutelsat 28A..Astra1N/2A/2B
Port B: 28.2E Eutelsat 28A..Astra1N/2A/2B
Set voltage and 22Khz: Yes
Send DiSEqC only on satellite change: No
Tuner B: AVL2180 (DVB-S2)
Configuration Mode: Simple
Mode: DiSEqC A/B
Port A: 28.2E Eutelsat 28A..Astra1N/2A/2B
Port B: 28.2E Eutelsat 28A..Astra1N/2A/2B
Set voltage and 22Khz: Yes
Send DiSEqC only on satellite change: No
I can correct the failure by going into 'Sat finder' (in 'Service searching') selecting a tuner and toggling between Tune> Manual transponder and Predifined transponder, exit, then selecting 'yes' to Zap back to service before sat finder.
Now that I think about it, I don't think it's happened since changing to Rob's Magic HD skin, but if anyone can see any errors with my tuner set up - please let me know.
Thanks
shaft.