Control TV Volume/ On-Off with VU+ Remote

[hsbajwa316]

Hi All

Had a scan on the net and couldnt find any resolution.

Is there a way to control the TV (and amp?) using the VU+ Remote

I have VU+ Duo, Panasonic TX-L50G10B and Onkyo TXSR507

Thanks in advance

[Larry-G]

Hi All

Had a scan on the net and couldnt find any resolution.

Is there a way to control the TV (and amp?) using the VU+ Remote

I have VU+ Duo, Panasonic TX-L50G10B and Onkyo TXSR507

Thanks in advance

If you have the newer vu remote you can program it to do pretty much what you want, or try enabling HDMI CEC on the receiver.

Sent from my GT-I9300 using Tapatalk 2

[Trial]

Hi,
you can see if you have a new or old remote on the top left. When you have a TV button on the top left you have a new RC. The DUO manual is not complete when it comes to program the RC look in the web for the UNO manual.

ciao

[hsbajwa316]

Hi I have the new remote, how do i go about this

[Trial]

Hi,
download and read the UNO or Ultimo manual there is a chapter about programming the RC.

ciao

[s31teg]

remote is simple

hold down 1+3

type 0000

then hole the tv power (top left) until tv goes off

when it does let go

now press ok +stop

all done

[hsbajwa316]

Hi the above didnt work, ill try downloading the manual

[hsbajwa316]

Hi All, still not working and now when I press the STB power off button its putting the TV on standby and when I turn it back on it keeps putting the wrong HDMI channel on. Is there any way to rest all this and go back to normal I have tried 1+6 , 996 and taking the batteries out but its not changing anything.

[s31teg]

1+6 996

that does reset it back to default

[Rob van der Does]

If you did the '1+6 996 trick' the R/C is back to default and not operating the TV.

Did you have a look at the HDMI-CEC plugin? Is it set to disabled?

[chaser]

You can force the Panasonic to startup on any HDMI input. Google for 'Panasonic Hotel Mode'.
Also, be careful when using the remote setup procedure detailed above. I found that the remote would find a code which could power my panasonic TV on and off, but would not operate the volume. To get around this, after entering 0000 on the remote, I would keep either the volume up or volume down button pressed until the TV volume started working. The remainder of the setup procedure was the same.

[hsbajwa316]

Hi All thanks for all your help didnt manage to get it working so have just disabled it, thanks for tip around the hotel mode works like a charm ;)

[conwaysly1961]

hold down 1+3

type 0000

then hole the tv power (top left) until tv goes off

when it does let go

now press ok +stop

all done
this does work but can take a long time just done it on my solo 4k took about 10 minutes :D