View Full Version : Mount network drive in the new vix 3 image
Does any one get it to work??
Mount network drive in the new VIX 3 image?
Rob van der Does
26-09-12, 22:11
Yes. Are you using NFS or cifs?
I have tryed both. i have a dlink 323 nas and a 320nas and canīt mount any one.
It works with older image. vix 2.4
Rob van der Does
27-09-12, 05:50
Not sure than what is wrong. Works fine here, and never had an issue with this.
hey
since yesterday I updated my xtrend to version 3 can't mount my pc,laptop's shared folders
installed NFS-running fine,installed samba- setup doesnt run.
can someone post a tutorial for vix3 cuz tut like (username vu password vu folder vu) doesnt work here.network browser is useless at all(expand-collaps nothing more).
how to install samba manually ?
I had to go through NFS Setup before I could mount my Qnap. Once that was installed it was exactly the same as in ver 2.4
samba status - stopped & it wont start
nfs doesnt work for me it didn't in vix2.4 too.
cifs was working just fine but now it wont start after install.
Rob van der Does
28-09-12, 21:49
samba status - stopped & it wont start
nfs doesnt work for me it didn't in vix2.4 too.
cifs was working just fine but now it wont start after install.
If Samba doesn't start you're not on the latest build; this has just been fixed.
NFS mounts do work fine, but your NAS must have the correct settings to allow that.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.