dbitalia
06-09-12, 22:04
Im having an issue since reinstalling VTI 4.2
I reinstalled the image and setup my motor with the following :
Config mode: Simple
Mode: Positioner
Longitude: 000.700 East
Latitude: 051.500 North
I know these are the correct settings as this is the config used by the installer & has been working fine until i reinstalled the image.
Its definitely not the hardware as i restored the factory Vu image along with default sat lists and i was able to view without issues. It must be something in the image as when i move sats and select a channel i will get picture & sound for s split second then it goes blank?
Any ideas as i cannot see where I'm going wrong
I reinstalled the image and setup my motor with the following :
Config mode: Simple
Mode: Positioner
Longitude: 000.700 East
Latitude: 051.500 North
I know these are the correct settings as this is the config used by the installer & has been working fine until i reinstalled the image.
Its definitely not the hardware as i restored the factory Vu image along with default sat lists and i was able to view without issues. It must be something in the image as when i move sats and select a channel i will get picture & sound for s split second then it goes blank?
Any ideas as i cannot see where I'm going wrong