View Full Version : can i run my old et9000 image again?
I have recently updated my et9000 box with a bootloader30.09.11 (Et9000) and change it to et9x00. after flashing the box it seem i am no able to flash my old image wiht the et9000 perfix and it olnly flashe files with et9x00 perfix. i would greatly appreciate if someone could help me out with this problem.
please dont ask me why i want to downgrade my box. i need to do that for some reasons.
please please please help me i am really desperate.
basilyoung
22-08-12, 19:50
sorry, but can not be reversed
could you kindly tell me why it is irreversible. there must be some way out.
basilyoung
22-08-12, 20:04
the units drivers ( boot loader ) can not be down graded, its a quirk of the 9000 series,
the only way with this unit is forward, not backwards,
you know i have a problem with card server connection in my cccam. i copied cccam.config in etc and ran cccam221. i am now using vix image and i am greately satisfied.Everything works fine, except my connection to card server which i think is due to new et9x00 image. my old image was egami.
others have had the same problem:
removed link _ stanman
what should i be doing to at least to have my server connection back to use my remaing 6 month account.
Ps: thanks for you support and immediate answer
Mr. Mister
22-08-12, 20:42
Sorry buddy..
No card sharing talk allowed in this forum..
Thread closed..
1. You have an infraction for card sharing talk - against forum rules, you are very lucky I did not ban you for pay server crap.
2. Just to dispel the myth, the image has no effect on your card sharing ability, very likely the shit you bought it from has too many paying idiots on it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.