tuggyman
11-08-12, 02:47
Hi,
My sat dish is around 2 degrees off and with my old spiderbox i could set to usuals or for automatic tracking, or 1.2 to allow for manual set up of tracking and triming to offset dish.
With my New UNO (very happy with), it only allows 'Positioner' in 'Mode field', on tuner config. (Usuals)
When i try to adjust position to trim signal in 'Positioner setup', it will not save refined position and satellite resorts to original position.
Is there a way to create an offset or do i have to brave the ladders to adjust?
Also are the default settings for motor controls correct? (turn step 0.360, Horz 2.3, vert 1.7)
My sat dish is around 2 degrees off and with my old spiderbox i could set to usuals or for automatic tracking, or 1.2 to allow for manual set up of tracking and triming to offset dish.
With my New UNO (very happy with), it only allows 'Positioner' in 'Mode field', on tuner config. (Usuals)
When i try to adjust position to trim signal in 'Positioner setup', it will not save refined position and satellite resorts to original position.
Is there a way to create an offset or do i have to brave the ladders to adjust?
Also are the default settings for motor controls correct? (turn step 0.360, Horz 2.3, vert 1.7)