lumberjack
05-07-12, 20:27
I have 2 vu+ solo boxes, 1 with openpli and working fine with the cccam.cfg file in the etc dir.
I have switched that off and connected the other then flashed vix 2.4 however I can not get channels to clear using same working cfg file.
I had sent via email (thanks mr mister) the correct plugin & installed it. "enigma2-plugin-cams-cccam.2.2.1_1.0-r0_mipsel.ipk"
'MENU'
'SETUP'
'SOFTCAM/CI
'SOFTCAM MANAGER'
CCcam.2.2.1 highlighted so I clicked the green button to start the cam and it shows 'Active:'
I then clicked blue to enable startup, exited out then rebooted.
I also installed CCcam.cfg in /etc .
Checking shows it is running but nothing clears other than fta.
If I swap back to other box (which has the same working test CCcam.cfg) with openpli everything is fine.
Any ideas anyone please?
thanks
I have switched that off and connected the other then flashed vix 2.4 however I can not get channels to clear using same working cfg file.
I had sent via email (thanks mr mister) the correct plugin & installed it. "enigma2-plugin-cams-cccam.2.2.1_1.0-r0_mipsel.ipk"
'MENU'
'SETUP'
'SOFTCAM/CI
'SOFTCAM MANAGER'
CCcam.2.2.1 highlighted so I clicked the green button to start the cam and it shows 'Active:'
I then clicked blue to enable startup, exited out then rebooted.
I also installed CCcam.cfg in /etc .
Checking shows it is running but nothing clears other than fta.
If I swap back to other box (which has the same working test CCcam.cfg) with openpli everything is fine.
Any ideas anyone please?
thanks