Remove Bouquet

[lammy1961]

I have installed a modified version of Catseye E2 Settings File 75 East - 58 West 30.06.2010...I edited out a lot of satellites that I don't use....Anyway I'd like to start from scratch with a blank canvas.
How do I go about removing this modified version that I installed ?
I'm going to start off with this latest bouquet...Sly UK Bouquets v3.2.1 August 25th 2010.

Thanks in advance.

[Mr. Mister]

You can find your satellites.xml file in tuxbox in your ftp programme

[lammy1961]

You can find your satellites.xml file in tuxbox in your ftp programme

Yes....What do I do with that ? Delete It ?
What about the files in /etc/enigma2/...What do I do with them ?

Thanks for the quick reply.

[bobonthejob]

Just create your new settings using dbedit and then FTP files over, have the remove unused bouquet selected. This should remove all old file and replace with the new files.

[lammy1961]

Thanks for the replies....I'll give it a go.

Cheers.

[lammy1961]

I have done this, but now I can only watch 28.2 east.....how do I get the dish to move to the rest like 16e which are greyed out ?

Thanks.

[bobonthejob]

Sounds like your satellites.xml file may not have a complete list of satellites on it.

Download some new settings from the E2 settings section and use the satellites.xml file from the downloaded bundle.

[lammy1961]

Thanks very much for the reply, can you reccommend a specific set ?

Thank you.

[Sicilian]

Thanks very much for the reply, can you reccommend a specific set ?

Thank you.

Look in our Enigma2 settings section. Download them and open them in Dreamboxedit or Dreamset so you can see if you like them or not. You can then modify prior to sending to your receiver.

[lammy1961]

Thanks for the replies.....Pio, bobonthejob and Sicilian....I downloaded Catseye E2 Settings File 75 East-58 West 20.08.2010, I edited them in DreamBoxEdit........Saved them to the Vu+ Duo.......They are all as I want them.....However every time I have done this I need to do a full satellite scan......?
Is this normal ?

[Sicilian]

Check out this guide http://www.vuplus-support.co.uk/showthread.php?623-How-to-send-save-Enigma-Settings-to-the-VUDuo-using-DBEdit Make sure the paths of where the files are sent too are correct.

[lammy1961]

I'll do that...Thanks.