PDA

View Full Version : tuner problem after standby Vix 2.4 latest


abster
20-05-12, 11:48
not sure exactly what is happening, but i think after having the duo in standby only one tuner is coming back on

i had a scheduled recording and once it started only channels from that transponder were available...

checked what was recording and it was only the one movie

went into setup and checked each tuner, they were fine, but everything was ok once i exited the tuner scanning/setup..

not sure uf anyone else is encountering this... only just changed to Vix from blackhole which was fine

cheers
abs
mcquaim
20-05-12, 11:51
Can you elaborate on your tuner setup?
Larry-G
20-05-12, 11:51
I'd check the feed into the affected tuner to make sure it is not loose or shorting, check the f-plug to make sure it is a snug fit and there is no play.
basilyoung
20-05-12, 11:53
So it appears that going into Tuner Config, " woke up" the 2nd tuner,

that is a bit strange, as yet, no other reports of this happening
abster
20-05-12, 19:20
both set as simple, static dish, pointing to sly...

it is like it woke up, everything tight cable wise, the box locked up about an hour after this, just had spinning vix logo top left, had to force off.

will report any further strangeness!

cheers
abs
alphajuliet
14-04-13, 11:44
im having this same problem on the mara/odin M9 openViX image.

not sure ... is there a fix?
Larry-G
14-04-13, 11:47
im having this same problem on the mara/odin M9 openViX image.

not sure ... is there a fix?

This thread is almost a year old and with a different image version.

It would be best for you to create a new thread for your problem, also list exactly which image your using including the build number and we can go from there.
judge
14-04-13, 11:47
im having this same problem on the mara/odin M9 openViX image.

not sure ... is there a fix?

Vix 2.4 will never be the latest...
are you still on 2.4 or reporting the same issue on a current build?
Larry-G
14-04-13, 11:52
Vix 2.4 will never be the latest...
are you still on 2.4 or reporting the same issue on a current build?

cant be using 2.4 on the mara / odin 9 as that image was never made for that receiver.