View Full Version : [ET9x00] Cam not restarting
My mgcamd is not restarting when I restart enigma, it is set to auto restart, any ideas?
Mr. Mister
20-02-12, 01:00
Go to your mg_cfg file
Change B from {00}
To : B {06}
that should cure your problem..
Nope, cam is setup fine and works when I do a manual restart, just does not start when I restart enigma.
Mr. Mister
21-02-12, 00:44
What version mgcamd you using.. ??
1.35a I switched to oscam and that worked fine for a bit and now I am back to Mgcamd
Mr. Mister
21-02-12, 01:22
Sorry buddy.. Thats what i was using also and all was working fine..
I did find a few issues like this with my Vix 2.3 image though.. So i went back to 2.2.1 and all have been fine since..
I have 1 duo with 2.3 on it.. but no updates are done.. and all is fine with that also..
sorry buddy.. cant help any more than this..
I have only experienced it on 2.3. I am back to mgcamd will monitor it.
Sent from my Galaxy Nexus using Tapatalk
ukdirtyboy
23-02-12, 23:38
yep same problem here mgcamd has to be restarted even if set to start on startup with green tick in box
also on 2.3 on uno
let me know if you find out why
cheers
Seems to be OK now that I have switched the auto cam checker off.
I noticed on startup that it was running the check and I was getting no picture.
Give that a try
Sent from my Galaxy Nexus using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.