View Full Version : hdmi problem with vu ultimo
Hi,I have a problems wth vu ultimo,I wait you understand my english because is very bad:
When I turn off my tv and turn on hdmi is lost,I can't see image from vu ultimo,if reboot my ultimo I can see image again.
my tv is: thoshiba 32AV555DG
and I have other problem with remote control,when I turn up/down volume of my remote control of my vu+ultimo it turn up/down volume of my tv, no of my reciver.
Go into HDMI CEC in the menu and disable forward volume keys. Also have a look for output as well.
I have the Ultimo on HDMI and no issues whatsoever.
Also we have an international section as well so you can post in your native language - makes live easier as some times difficult to get a point through in another language.
menu> setup> system> HDMI CEC. set enabled to no then press green to save.
I have disable hdmi-cec but no work
Rob van der Does
18-02-12, 19:30
It is known that sometimes HDMI-incompatibilities exist between devices. It would be good to report them to VU+, as they're the only ones who can look into that (and eventually resolve that).
Go into HDMI CEC in the menu and disable forward volume keys. Also have a look for output as well.
I have the Ultimo on HDMI and no issues whatsoever.
Also we have an international section as well so you can post in your native language - makes live easier as some times difficult to get a point through in another language.
sorry stanman,I can't see spanish lenguage
It is known that sometimes HDMI-incompatibilities exist between devices. It would be good to report them to VU+, as they're the only ones who can look into that (and eventually resolve that).
yes rob,I send a email today.thanks
and I have other problem with remote control,when I turn up/down volume of my remote control of my vu+ultimo it turn up/down volume of my tv, no of my reciver.
ok,I resolved it with:
Reset of TV Set-up
In case you want to reset the configured TV set-up of your RCU,
Press Sequence: <<1 + 6>>, <9>, <9>, <6>
1. Press 1and 6 for three seconds until LED is on.
2. Press <9>, <9>, <6>.
3. This will reverse the RCU into no configuration state.
Hi,I have a problems wth vu ultimo,I wait you understand my english because is very bad:
When I turn off my tv and turn on hdmi is lost,I can't see image from vu ultimo,if reboot my ultimo I can see image again.
my tv is: thoshiba 32AV555DG
It is solved with new beta drivers.thanks all
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.