PDA

View Full Version : A little help please!


v_j_r
23-01-12, 20:11
I need some help as new owner of VU+ Ultimo, i originally have a DM8000 (which i still have) in which i was using Cccam the CFG file i was using was one created that included a boxkey for my N** card UK.

I have FTP'ed this CFG file to my ultimo but CAM info shows that it is not seeing the cardreaders? is the format different in the VU+ is there a CFG creator availible for use with the ultimo please any help would be gratefully recieved.


Regards.:D
fintannl
23-01-12, 20:21
check the sci value in the config and make sure you put the card in the correct sci slot be it sci0. sci1 or whatever
Trial
23-01-12, 20:31
Hi,
which image do you use? In an original image vucamd already uses the reader. If you are on OI edit bootup file and remove vucamd or rename CCcam to vucamd or use ViX.

ciao
bassethound
23-01-12, 20:45
Move to the correct section!

Dont post questions in the downland section!
v_j_r
23-01-12, 21:40
Where are the softcams etc in Vix image many thanks.


Regards.
fintannl
23-01-12, 21:47
not available on vix. found at

http://www.4shared.com/dir/wnyHV50A/VIX_CAMS.html
just load into /tmp folder and use the ipk installer to load
Stanman
23-01-12, 23:04
No live links please.