silent_hill_dan
16-01-12, 09:18
Good morning all,
I'm using Vix 2.3.161 on ET9000 and have a question about the infobars.
When I press OK on the remote, the 1st infobar appears, when I press OK again, the 2nd infobar appears - so far, all fine.
In the settings I have:
infobar timeout = 3 seconds
2nd infobar = Event Info
2nd infobar timeout = 3 seconds
However, the 2nd infobar never disappears after 3 seconds, it just stays on the screen until I press OK/Exit again....
Is anybody experiencing the same ?
I'm using Vix 2.3.161 on ET9000 and have a question about the infobars.
When I press OK on the remote, the 1st infobar appears, when I press OK again, the 2nd infobar appears - so far, all fine.
In the settings I have:
infobar timeout = 3 seconds
2nd infobar = Event Info
2nd infobar timeout = 3 seconds
However, the 2nd infobar never disappears after 3 seconds, it just stays on the screen until I press OK/Exit again....
Is anybody experiencing the same ?