nikolakis0644
11-01-12, 16:59
Hi to all
I bought a new VU+ Uno, and I installed a 2.5 Seagate 320Gb hard disk. I boot it with the stock image to apply FPGA Update. I check the hard disk and the disk WAS RECOGNIZED by the stock image. After that I intalled the BH 1.7.0 in the flash, flashing went Ok, but when I go to extra panel, Hard disk, I have the message no hard disk.
Why am I doing something wrong?
Thanks in advance
I bought a new VU+ Uno, and I installed a 2.5 Seagate 320Gb hard disk. I boot it with the stock image to apply FPGA Update. I check the hard disk and the disk WAS RECOGNIZED by the stock image. After that I intalled the BH 1.7.0 in the flash, flashing went Ok, but when I go to extra panel, Hard disk, I have the message no hard disk.
Why am I doing something wrong?
Thanks in advance