installing mgcamd

[jackobeen]

hello,i have vu solo with black hole 1.6 image and
cccam 2.2.1.would it be possible to install mgcamd
with this image.would i have to delete my cccam 2.2.1.
thanks,hope someone can point me in the right direction.

[Mr. Mister]

Hi.
you should be able to install both with no issues..
although i have never used blackhole.. so i can not say that it will work on that.
But i do know that it works perfectly with the VIX images.. on both Solo`s and Duo`s
You just choose which softcam you want to run in your softcam manager..
Just leave you cccam.cfg file in and leave your MGcamd files in there respective folders..
hope this helps

[jackobeen]

i have found a file mgcamd 1.36 for blackhole,
but would this be compatable with my 1.6 image.
thanks.

[notanotherone]

you can put cccam or mgcamd on its just a matter of choosing which one you want to run i use 1.35a

[jackobeen]

thanks for the reply,
have found this file for b.h.image.
mgcamd 1.37 e2 bh.tgz.
read somewhere this goes into tmp folder
and then manual install.
going to try tomorrow.

[jackobeen]

@mr mister,when you said leave your MGcamd files in there respective folders,
what would these be please,are these in the cc cam config file.

[delboy13]

once cam installed Ftp mg_cfg & newcamd.list to /usr/keys

[rmprest]

Hi all,

I'm trying to do this (on an Uno) but not having much luck

I've got the mgcamd installed and activated but i'm not clearing anything, cccam works fine.

What im sturggling with is the newcamd.llist file, i've seen a tutorial but i'm not sure if its right

CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 21000
CWS = 192.168.1.1 20000 dummy dummy 10 02 13 04 15 06 17 08 01 10 11 12 13
14


Would my cws be 192.168.1.1 ??

I'm so close to sorting it but just need some extra help !

[jackobeen]

@rmprest ,did you get your problem sorted,i am in the same situation as you.
have been given an n-line but cant get it to clear.
@delboy 13,i have installed the mgcamd 1.37 installed Ftp mg_cfg & newcamd.list to /usr/keys .
do i enter N at the beginning of the last line in newcamd.list file,or do i use CWS =.
thanks.