smargo not detected on Clarke-Xtrend Support Image V3 ** Linux 3.03 **

[ablyes]

Hello,

What must i do to have my smargo working under Clarke-Xtrend Support Image V3 ** Linux 3.03 ** ?
The smargo is under cccam 2.2.1, and was previously working on VIX image 2.0 (cccam 2.1.3)

The lines i use:


SERIAL READER : /dev/ttyUSB0 smartreader+
SMARTCARD CLOCK FREQUENCY: /dev/ttyUSB0 6800000

I tried with:
- ttsUSB0 instead of ttyUSB0
- USB1 port and the good lines
- witouth the lifne SMARTCARD CLOCK ...
- rebooting the box with the smargo, without, ...

Thank you.

[rossi2000]

are the smargo drivers actually present in the image?

might be worth checking out before trying all sorts of things which wont work if the drivers aint there...

[basilyoung]

SERIAL READER : /dev/usb/tts/0 smartreader+

this works on both my 9000, and duo

[ablyes]

SERIAL READER : /dev/usb/tts/0 smartreader+

this works on both my 9000, and duo

Is it working on the image Clarke-Xtrend Support Image V3 (Linux 3.03) ?
Because i tried your line, and still have the same message:


card reader /dev/usb/tts/0
no or unknown card inserted

card reader /dev/ttyUSB0
no or unknown card inserted

[basilyoung]

what card is it, you are trying to use, and with what method??

[basilyoung]

also, is the reader configged ok, ie: dreambox mode?

[ablyes]

The solution was to install ftd_sio packet on packet manager.