Using the Tenda W150M

[wazza_2]

hi i am Using the Tenda W150M , well i would be if i could get it working. i am strugling to get past were i put 192.168.2.1 into my laptops browser, on the installer it says to Power up the W150M using supplied USB lead or PSU.Press Mode button until Client+AP blue LED is alight.plug in the ethernet cable. Go to Control Panel > Network Connections > Change Adapter Settings > Right Click over
Network connection > Select Properties. Click on TCP/IProl IPv4 > Click Properties,Now set IP to 192.168.2.100 and subnet mask to 255.255.255.0 , then says to go into your web browser and type in 192.168.2.1 ???/???? nothing happening , any ideas guys

[punisher]

Thats probably because you havent mentioned if you assigned the default gateway ip i the adapter settings as well as ip address and subnet mask

[Stanman]

Have you followed the instructions in the document attached to the first post here?

http://www.world-of-satellite.com/showthread.php?11478-Review-and-Guide-to-setup-the-Tenda-W150M-WiFi-N-150mbps-Wifibridge-for-all-Receivers&highlight=Tenda+W150M

[Larry-G]

once you have changed the above settings you may need to reboot the pc / laptop so that the settings can take effect properly.
i know i did when i set mine up.