mcquaim
22-09-11, 09:45
Hi folks,
I just recieved my TM800 HD from our sponsor and when I boot the receiver up the message "Loading PLi-E2 iQ" just stays on the front panel.
The remote is not responding nor are the buttons on the front of the receiver. I thought this receiver was shipped with the image pre-flashed?
Perhaps I just need to flash it myself?
Thanks,
mcquaim
I just recieved my TM800 HD from our sponsor and when I boot the receiver up the message "Loading PLi-E2 iQ" just stays on the front panel.
The remote is not responding nor are the buttons on the front of the receiver. I thought this receiver was shipped with the image pre-flashed?
Perhaps I just need to flash it myself?
Thanks,
mcquaim