ET9000 doesn't boot after flashing!!!

[mkr]

I'm a fresh owner of CLARKE-TECH ET9000 HD.
Yesterday I tried to install a new image OpenPLi-2.1-beta-et9000-20110912_usb from
http://www.pli-images.org/modules/file_downloads/file_downloads.php?fd_id=1&dir=/et9000

After unzipping I stored the content:
Imageversion
kernel.bin
noforce
rootfs.bin

under the et9000 directory on a FAT32 formatyted USB key.

Next executed steps:
1. Place the USB key into the fron USB
2. Start CLARKE-TECH ET9000 HD turning the power switch ON
2. The system has detected the image software
3. Confirm pushing OK
4. The system started the flash procedure - "flashing...." message was displayed.
5. After the successfully flash the message "booting..." was displayed and nothing happened
6. The USB key was still connected.

Can someone tell me what I have to proceed to solve the problem? Is id possible tha the bootloader has damaged? The specification assures that the bootloader cannot be damaged because of a separate memory.
Maybe I should install all the firmware ? If yes , which firmware, (versions), in which order an where can I find it?
Can someone give me a suggestion?
Thanks.

[Sicilian]

Have you flashed the latest bootloader with UBIFS support? Post 13 here http://www.world-of-satellite.com/showthread.php?6380-Latest-ET9000-Bootloader-and-Drivers-updates/page2

[mkr]

Thanks for your reaction.
No, I didin't. Do you mean this file? et9000-drivers-gcc44-20110707.zip‎

[Sicilian]

Post 13 here http://www.world-of-satellite.com/showthread.php?6380-Latest-ET9000-Bootloader-and-Drivers-updates/page2 Bootloader update 19-07-2011

With UBIFS support

You need latest bootloader to use Openpli 2.1

[mkr]

OK, I found it. It is all or I need also other things?

[Sicilian]

Flash the booloader like you flash the image. Once the bootloader is done, re-flash the image.

[mkr]

Thanks for your assistance. I'll try it tonight...and 'll tell you the results.
Thanks a lot.

[mkr]

Many Thanks Boss. It works fine!

[silverfox0786]

glad yr sorted matey

:D