Clarke tech et9000 loop through

[zeurss]

Hi i want to use the loop to use in another room i have a cable that was used from the rf2 out on my last reciever will that work,or will i need to run a cable straight from the dish.I dont mind watching the same feed just existing cable will work.Also could anyone recommend a cheap altenative box that is a good second box thanks.

[Larry-G]

to use the lnb loop through feature you need to run a length of coax from the lnb out on the et9000 to the lnb input on the other receiver. also note that this feature will only work when the et9000 is in deep standby otherwise no signal will be passed to the second receiver.

you best bet is to get a dual or quad lnb therefore having a full feed to each receiver, so each works independently