Since setting up my Et10000 about two months my hard drive has not mounted on a few occasions.

After initial setup of the box and initializing of the HDD, the box was rebooted and the hard drive wasn't mounted...
I restarted the box through the UI and it mounted ok!

Its also happened on 4 other occasions, rebooted the box and it mounted ok.

I do have a Power schedule setup, deep stand-by starts at 23.55 and finish's at 6.30 and goes into standby.

I ran file system check and HDD is ok, i have also re-seated the SATA and power cable attached to HDD.
The only thing i have done is change the SATA cable, when i get one i will test this.

Has anyone seen this or is there anything else i can check?

Thanks