It seem's most of you, have missed the thread.....

[andyblac]

so i posting it again here.

PLEASE READ IT


Important Announcement.

'From build 760 onwards the video-mode selection has been completely overhauled. It is no longer merely a plugin, but has been embedded as an integral part of the image.

It is now necessary to reflash your receiver, a online update will cause issues. Before flashing you can use the BackupManager to make a settings- and plugin backup. If done, you can flash in the usual way and during the First Install Wizard you can use the restore function to restore your backup. This way your box will be up & running in a couple of minutes.

Once the image is up and running, you should go to Menu> Setup> AV-settings, and make the settings in accordance with your setup.'

[Foxylady]

Cheers Andy,
I always do a fresh reflash without backup as it doesn't take me long to put everything back in manually.
Right! so the answer is clear and final, All i needed
Best wishes

[duoduo]

Hi Andy, after a new reflash will online updates be standard going forwards?

[Larry-G]

Hi Andy, after a new reflash will online updates be standard going forwards?

yes, it's just that the update in 760 is so complicated it needs to be a full flash to eliminate a lot of problems that would otherwise come from online updating.

[bartjunited]

where can i read about the changes in build 760 and the video selection mode?

should this help my issue with my receiver not switching on at times?

[Rob van der Does]

where can i read about the changes in build 760 and the video selection mode?

See post #1 above.

should this help my issue with my receiver not switching on at times?

Nope .

[zoro25]

Once the image is up and running, you should go to Menu> Setup> AV-settings, and make the settings in accordance with your setup.'[/I]

I think you mean Menu>Setup>System>AV-Settings (System was missing from your above walk through in OP)

[craig37]

Hi andy, carried out back up of box. downloaded 760 on to flash drive. Powered off unit and instal usb stick. powered on (update) shown Pressed power button and update started, minute later screen reads (checking usb) Has been on this for twenty minutes ?

Is this normal?

Cheers

[khan888]

Hi andy, carried out back up of box. downloaded 760 on to flash drive. Powered off unit and instal usb stick. powered on (update) shown Pressed power button and update started, minute later screen reads (checking usb) Has been on this for twenty minutes ?

Is this normal?

Cheers

Once the box has updated you need to remove the usb stick and reboot the box, should load up fine after that

[craig37]

Switch off box Removed stick Powered up but still running 753. Download 761 and same thing has happened Will try a different stick.. Have format to fat 32 and ejected correctly from laptop

[Rob van der Does]

Why not download the image via the image manager and flash from there? No hassle with sticks and even much faster.

[sparky72]

sorry to butt in but where is the image manager .... i have always had to flash from a stick and dont find it reliable

again sorry to butt in

thanks

[Stanman]

blue button/VIX

Sent from my GT-I9305 using Tapatalk

[sparky72]

thanks i will try it now

[fast65]

Why not download the image via the image manager and flash from there? No hassle with sticks and even much faster.

thanks for that Rob. Works a treat
regards