[ET9x00] Cam not restarting

BadBoy · Feb 19, 2012

My mgcamd is not restarting when I restart enigma, it is set to auto restart, any ideas?

Mr. Mister · Feb 20, 2012

Go to your mg_cfg file

Change B from {00}

To : B {06}

that should cure your problem..

BadBoy · Feb 20, 2012

Nope, cam is setup fine and works when I do a manual restart, just does not start when I restart enigma.

Mr. Mister · Feb 20, 2012

What version mgcamd you using.. ??

BadBoy · Feb 20, 2012

1.35a I switched to oscam and that worked fine for a bit and now I am back to Mgcamd

Mr. Mister · Feb 21, 2012

Sorry buddy.. Thats what i was using also and all was working fine..

I did find a few issues like this with my Vix 2.3 image though.. So i went back to 2.2.1 and all have been fine since..

I have 1 duo with 2.3 on it.. but no updates are done.. and all is fine with that also..

sorry buddy.. cant help any more than this..

BadBoy · Feb 21, 2012

I have only experienced it on 2.3. I am back to mgcamd will monitor it.

Sent from my Galaxy Nexus using Tapatalk

ukdirtyboy · Feb 23, 2012

yep same problem here mgcamd has to be restarted even if set to start on startup with green tick in box
also on 2.3 on uno

let me know if you find out why
cheers

BadBoy · Feb 29, 2012

Seems to be OK now that I have switched the auto cam checker off.

I noticed on startup that it was running the check and I was getting no picture.

Give that a try

Sent from my Galaxy Nexus using Tapatalk

[ET9x00] Cam not restarting

BadBoy

New member

Mr. Mister

Moderator ,

BadBoy

New member

Mr. Mister

Moderator ,

BadBoy

New member

Mr. Mister

Moderator ,

BadBoy

New member

ukdirtyboy

New member

BadBoy

New member

Similar threads

OpenViX Feeds Status