Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Page 2 of 2 FirstFirst 12
Results 16 to 19 of 19

Thread: Sundtek Sat USB tuner setup issues

  1. #16
    dsayers's Avatar
    Title
    ViX Beta Tester
    Join Date
    Mar 2016
    Posts
    1,752
    Thanks
    472
    Thanked 606 Times in 432 Posts
    Ok tried another box and image and still the same, I am trying the Sundtek chat and logged in the above link but not sure how to start a conversation or who to talk to. Ill raise a support ticket with WoS to see what they can advice as im thinking there is no power going into the tuner and no sign of a light as per jawz instructions but he said he has a different model so im not sure if there is anyway to tell if it has power.
    Last edited by dsayers; 27-09-17 at 16:02.

  2. #17

    Title
    Senior Member
    Join Date
    Aug 2016
    Location
    Ireland
    Posts
    112
    Thanks
    127
    Thanked 26 Times in 18 Posts
    I don't use my usb tuner full time, only bought it so i could get some recording for the Irish provider. I just plugged mine in and used the desktop program to install the drivers and all working fine.

    I plugged the tuner into the usb port on front of my receiver and then plugged the coax cable into the tuner. I then rebooted the receiver and went to my laptop and used the program to install the drivers, the desktop program reboots the receiver too, so once it restarts all was working as it should.

    Here is my tuner, which you will see the light which i was talking about.
    20170927_160501.jpg

  3. #18

    Title
    Senior Member
    Join Date
    Aug 2016
    Location
    Ireland
    Posts
    112
    Thanks
    127
    Thanked 26 Times in 18 Posts
    @dsayers are you changing any of the settings within the sundtek control center? As i didn't have to change anything within this menu. Even in the tuner config menu i didn't even have to enable it, once it rebooted it was already enabled and good to go

  4. #19
    dsayers's Avatar
    Title
    ViX Beta Tester
    Join Date
    Mar 2016
    Posts
    1,752
    Thanks
    472
    Thanked 606 Times in 432 Posts
    I have managed to contact Sundtek they are looking at replacing it we tried it in windows and its not being discovered so there is a fault somewhere.

  5. The Following 3 Users Say Thank You to dsayers For This Useful Post:

    Bangord30 (27-09-17),el bandido (27-09-17),jawz (27-09-17)

Page 2 of 2 FirstFirst 12

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.