Hi guys, running a gigablue hd quad plus. ABM for 28.2 comes up with message CANNOT READ DATA. Virmin runs fine. this has only started happening today. Reflashed image and initial manual ABM worked but would not read data after that. Any ideas?
Hi guys, running a gigablue hd quad plus. ABM for 28.2 comes up with message CANNOT READ DATA. Virmin runs fine. this has only started happening today. Reflashed image and initial manual ABM worked but would not read data after that. Any ideas?
Your lnb / dish / cabling could have become affected by recent bad weather, the frequency ABM uses can have problems yet you can still useually tune loads of channels. Find the ABM frequency and try to manually lock on to it.
VU+ Ultimo 4K 3TB, 1x Twin DVBS-2 FBC / 1x DVB-C FBC/ 1x Twin DVB-T2.
VU+ Solo4k 2TB, 2xFBC-S2, 2xC/T2, 1x Sundtek .
1m Motorised Single LNB Dish, 60cm Fixed Octo LNB Dish.
Samsung 65HU8500 with SEK-3500, Denon AVR-X2200W 5.1.2.
Oppo UDP-203
Panasonic 55VT50.
Zidoo X9S
Amazon Fire TV 4k & Amazon Fire TV (SPMC sideloaded).
Rizhsn (23-01-17)
I had a feeling it could've been the cable. I got the old thin cable with flimsy connectors which keep coming loose. I'll try new cable and test the lnb and report back.
Ok the sat guy has been. Faults found;
Dish - reflection completely worn away (18 years old).
Lnb - only 57% signal.
Cable - Rg59 old with loose f connector.
Replaced dish and lnb. Now have 97% signal and Rg59 replaced with rg6 with compression fit connector. All is back to how it was now.
Bangord30 (23-01-17)
Cool. How much cost mate?
Sent from my VF695 using Tapatalk
Bangord30 (23-01-17)