Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Results 1 to 3 of 3

Thread: TM Nano SE M2 Plus stuck on openpli screen

  1. #1
    Akman's Avatar
    Title
    Junior Member
    Join Date
    Dec 2016
    Posts
    5
    Thanks
    4
    Thanked 0 Times in 0 Posts

    TM Nano SE M2 Plus stuck on openpli screen

    HI folks,
    I am a newbie to this reciever so please forgive my lack of knowledge. I have just purchased the above pre flashed and initially it could see the channels from 28.2 degrees. When I restarted it this morning I don't get past the openpli start up screen. I can see the percentage booting up but then it just sits. Any ideas please?
    Akman
    IMG_0285.jpg

  2. #2

    Title
    ViX Beta Tester
    Join Date
    Jan 2011
    Posts
    14,099
    Thanks
    3,389
    Thanked 4,102 Times in 3,198 Posts
    Does the remote still work? If so, looks like the box isn't getting any signal.
    If the remote doesn't work, look on the box for crash logs.

  3. The Following User Says Thank You to judge For This Useful Post:

    Akman (02-12-16)

  4. #3
    Akman's Avatar
    Title
    Junior Member
    Join Date
    Dec 2016
    Posts
    5
    Thanks
    4
    Thanked 0 Times in 0 Posts
    Thanks Judge. In the end I re-flashed the box with 4.2.020 and all is fine now.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.