User interface position needs resetting every day

[sarntech]

With Vix-night-HD, I have to keep resetting the interface position, by moving it up.
This needs to be done at least every day. Is there a way of making it staying in position?

[Andy_Hazza]

Yeah turn overscan off on your tv. This has been covered umpteenth times on the forum. E.g. If you have a Panasonic tv it will be call "overscan", if you have an LG tv it will be called "Just Scan" etc etc.


Sent from my iPhone using Tapatalk

[sarntech]

Yeah turn overscan off on your tv. This has been covered umpteenth times on the forum. E.g. If you have a Panasonic tv it will be call "overscan", if you have an LG tv it will be called "Just Scan" etc etc.


Sent from my iPhone using Tapatalk

Turned overscan off on Panasonic TV but the problem remains. I still can't see the bottom of the EPG.

[Andy_Hazza]

Make sure your Position Setup is set back to default. Menu > Setup > System > User Interface > Position Setup, then press yellow button to Defaults and then green button to save.


Sent from my iPhone using Tapatalk

[Rob van der Does]

(How) do you close/power-down/switch-off the box?

[sarntech]

Make sure your Position Setup is set back to default. Menu > Setup > System > User Interface > Position Setup, then press yellow button to Defaults and then green button to save.


Sent from my iPhone using Tapatalk

That did the trick.

thanks

[sarntech]

(How) do you close/power-down/switch-off the box?

press the power switch on remote

[sarntech]

Make sure your Position Setup is set back to default. Menu > Setup > System > User Interface > Position Setup, then press yellow button to Defaults and then green button to save.


Sent from my iPhone using Tapatalk

The problem has returned. I've pressed yellow to default but the EPG is not displaying properly. It is too far left.
Please help.

[Andy_Hazza]

Looks like your tv has defaulted back. Try a different HDMI port on your tv and turn overscan off again.
Please note, turn your tv n satellite receiver off/standby when swapping HDMI cables etc.


Sent from my iPhone using Tapatalk

[Rob van der Does]

Sounds like my brand new and expensive Philps TV that I've returned for this (and other) reasons; the demented TV forgot most of it's settings after a day or so

[sarntech]

Looks like your tv has defaulted back. Try a different HDMI port on your tv and turn overscan off again.
Please note, turn your tv n satellite receiver off/standby when swapping HDMI cables etc.


Sent from my iPhone using Tapatalk

Turned off overscan on TV again (not sure why it turned on again) and all is well again.
Thanks again.

[birdman]

Yeah turn overscan off on your tv.

When I do this on my Sony (set the picture to Full, which seems to be the only relevant option) I still need to use a positioner to position the menus (which seem to be overlaid in a separate frame buffer?).

[Rob van der Does]

What's the type of your Sony?

[birdman]

What's the type of your Sony?

It's a KDL-32EX723 (2011??).

Once I set the menu position all is fine.

[Rob van der Does]

Hmmm, manual as usual: hardly any info. What are the display settings you can choose? Fo rmy Sony the not-overscan mode is '+1', but naming may differ per type.

Anyway: you have overscan turned on atm, and you should not be happy with that.