I have performed a couch flash using Image Manager of OpenVix 4.0 002
without a Settings restore as it don't take long to setup what i need from scratch,
I went through the install wizard as usual
next job was to set my root password using DCC & DCC just wont fully establish a connection
So I tried VU Control Centre, connection was instant which allowed me to set a root password via telnet
& i used Filezilla to add timers, autotimers etc etc.
I have since tried to use DCC again it just wont fully establish a connection
Telnet Connected
FTP Connected
It just doesn't detect Enigma2
Any of you guys experiencing the same or is it just me ?
DCC works fine on my boxes that are flashed with OpenVix 3.2