ET6000 does ot load and turn on

[jazzB]

Hi All,


I need help in my box. I have a xtrend 6000 and suddenly the box don´t load and does not show the front lights, however I know that the box is ok because when I put a usb stick the box read but dont turn on. My guess is the issue is on the flash but I don´t have the sure. Someone has any idea what is or can someone tell how to make a hardware reset to factory settings ?

Thank you in advance for your help,
jazzB

[twol]

So load up the latest Vix image onto the stick and reflash...... power on with the stick in the front usb port, hitting the up button when it accesses the USB stick should do it.
Leave to flash and reboot (automatic after flashing) and hopefully will come up on your screen.
If that doesn't work try flashing the bootloader first - all to be found under the ViX Images (far right) tab on the top bar of this page.

[jazzB]

Hi twol,

thank ou for your reply, I will try and I will give you a feedback

[jazzB]

Hi twol,

nothing happens on the box. The leds doesn´t shine... I think is dead... Any more ideas?


Thank you in advance

[twol]

Hi twol,

nothing happens on the box. The leds doesn´t shine... I think is dead... Any more ideas?


Thank you in advance

I thought you said it tried reading the USB stick? Hence the suggestion of hitting the UP button when the usb stick light flashes - I realise that no lights on the receiver probably means it's dead, but thought it was worth seeing if it would still load up from the USB.

[twol]

Hi twol,

nothing happens on the box. The leds doesn´t shine... I think is dead... Any more ideas?


Thank you in advance

I thought you said it tried reading the USB stick? Hence the suggestion of hitting the UP button when the usb stick light flashes - I realise that no lights on the receiver probably means it's dead, but thought it was worth seeing if it would still load up from the USB.

[jazzB]

Hi twol,

the box when I switch to on on the rear button, the leds on the front panel does not shine, however the box still heating so I suppose it´s not dead but I don´t receive any signal from the usb stick.... Its not possible to do a reset settings from hardware in other way ?

Thank you for your time and your patience,

[mohamed1954]

Bonsoir j'etais entrain de flasher mon demodulateur xtrend 6000 avec une clef usb resultat mon demodulateur se bloque 2 temoins les rouge allumes,j'ai essaye plusieurs fois aucun resultat ,je voulais resoudre mon probleme avec l'appui de cable rs232 pas moyen meme IP de recepteur bloque aidez moi svp

[mohamed1954]

Bonjour a tous je cherche une image OpenVIX 3.0-729 pour Xtrend 6000 de Maumixio merci les amis

[Rob van der Does]

Désolée, nous avons seulement des images du séries Apollo.

[mohamed1954]

merci RAB VAN DER DOES

[mohamed1954]

merci Rob van der Does