As the title, guide in link below:
Code:http://archive.vuplus.com/download/vfd/vuduo2/20130719/
As the title, guide in link below:
Code:http://archive.vuplus.com/download/vfd/vuduo2/20130719/
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
aesthetiker (25-08-13),snakie (17-10-13)
What is VFD controller? and is it necessary to update it?
From the 20130722 drivers changelog (duo2):
- Improve VFD controller update(VFD controller update will resolve remote control sensitivity issue)
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Thank you for an answer!
Do you have to download then ftp to box if so where.
Just use the latest ViX image (i.e. build 705 or later) and follow the instructions in post #1.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
I had my new vu+duo2 just Yesterday and I have installed the CFE to update. How can I see in the decoder that upgrade is well done? In my decoder's info there was before and now ever version jun 20 2013 experimental factory and so experimental image 2013 06 20. I can upgrade new software only with USB key or I had to do with computer? What software can I install now ? Exuse me for my question, but I am new for Linus software. Thank you if you can give me some aids!
How did you 'install the DFE to update'?
You upload the bootloader exactly the same way as an image. The process can be followed on the G-VFD.
When done you'll see a short 'Duo2_CFE_V2' on the G-VFD twice during every reboot.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
domacio (11-08-13)
Upgrade was good. Now I installed black hole 2.0.5, all is fine!
Thank you for an answer.
Thank you for an answer nearly a year ago?